Strategies To Install A Amp To A Vehicle Radio
Posted By Henry Woody on February 4, 2010
The two very important properties of a audio system is its volume and sound quality. Addition of an amplifier to the car stereo is one of the best way to bring an improvement in the sound quality and clarity. This also helps in getting a clearer signal. Quality is enhanced to the whole of the audio spectrum in addition to improvement in volume. This gives fuller sound to the lower tones and makes the higher ranging sounds more crisper. A professional can install this amplifier to the car stereo. Even an individual can connect an amplifier. But how to connect an original car stereo to an amp?
The works requires the following tools to proceed. It will require screw drivers of the Philips company, a drill, a panel tool, a kit which contains amplifier wirings , groomets and spacers made of rubber. It will also require the use of wires and harness adapter.
A few tools are required to complete the job these make the job easy and faster. It includes speaker wire, rubber
grommets, wiring harness adapter, amplifier wiring kit, drill, Philips head screw driver, trim panel tool, rubber spacers.
Now the ring terminal of the amplifier, whose fuse has been removed, is connected to the positive lead of the battery. This ring amplifier is obtained from the kit. A screw driver may be used for this purpose. A hole is drilled in the firewall which is in the compartment of the car engine. This is used for the power supply of the amplifier. The wiring is protected using groomets. The amplifier is placed in the vehicle’s trunk. In case of trucks it is placed under the seat. Spacers are used in this case to provide ventilation.
The amplifier is mounted on the trunk of the car. In the case of trucks the amplifier is mounted below the seat to provide ventilation. The vehicle’s stereo is removed. The removal procedure varies from one vehicle to other. The manual which is issued along with the vehicle by the manufacturer is to be referred often. The stereo unit is pulled to the dash till the wiring in the rear.
In the next step a hole is drilled in the compartment of the engine so as to pass the battery power to the location where the amplifier is connected. A coating of rubber grommet is made on the wire to protect the opening. It always better to place the amplifier in the trunk. In case of a truck, the amplifier can be mounted in the space below the seat but one should ensure that there is enough air circulation in that place.
The stereo system of the car is removed. The process of removing it varies from one car to another and so it is better to go through the user’s manual before doing this job. Take out the stereo so that the wires in the back side of the stereo can be accessed easily. Now the wires attached to the stereo system are removed. Then the wires are connected to a adapter. This connection is easy to make because all the wires are colour coded.
Technology has made things easy and simple though it is complicated in its own working. The above article would have taught you how to connect an original car stereo to an amp. These works must be done with caution and accuracy. Thus take time to do this simple work with care.
Want to find out more about Car Hifi, then visit Author Name’s site on how to choose the best Car Audio for your needs.
Comments